The first dip building platform, going a long exposure during the construction base plate, occurs sticking to teflon film, when building platform lifting, building tray jumps up and breaks away from the building platform. When moving the slider moves slightly toward the tray(only after burning) . Each successive layer is sticks, in consequence occurs to tear off model from support in whole or in part. Also, base plate can break away from the building platform in a place where there is a pattern. The zero and slider was calibrated, glasses and parts are clean. Adjusting the normal exposure time was increased by 50%. The support width is 0.5.Should build platform touch teflon ?Why does it stick?Should exposition burning time be sufficient to polymerize the polymer so that it is not stuck? How do the calibration focus or it check?
I did not find the right solution from the internet.